| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| CW temperature sensor. | Rate Topic |
| Author | Post |
|---|
| Posted: 06-19-2014 06:13 pm |
|
1st Post |
|
Barthol Member
|
Hi I am mounting dellortoes on my jh, and I got the manifold with the "long cooling pipe" see attached photo. My problem is that there is no hole for the temp sensor. Any suggestions on where to fit the sensor? BR kim Attachment: lotus907.jpg (Downloaded 66 times)
|
||||||||||||||
| |||||||||||||||
| Posted: 06-19-2014 07:38 pm |
|
2nd Post |
|
gmgiltd Member
|
Normally its tapped in the water passage that is below and between the two carbs - if not that is where to drill and tap it. Attachment: Temp sender.jpg (Downloaded 64 times)
|
|||||||||||||
| ||||||||||||||
| Current time is 08:26 pm | |
| > Jensen Healey & Jensen GT Tech > Electrical & Instruments > CW temperature sensor. | Top |
