Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Realign crank with camshafts

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Realign crank with camshafts  Rate Topic 
AuthorPost
 Posted: 03-08-2014 01:10 am
  PM Quote Reply
1st Post
Art DeKneef
Member
 

Joined: 03-12-2005
Location: Mesa, Arizona USA
Posts: 298
Status: 
Offline
In getting ready to start the car I'm rebuilding discovered the water pump was leaking. So after replacing the water pump and gasket I also replaced the front cover seal and gasket. So I had to install the crank pulley again being careful not to tighten to tightly until everything was together again. One of my 'young' helpers thought they would help by tightening the bolt on the pulley for me. It moved but I don't know by how much.

Right now the timing belt and distributor cam wheel are off

So the question is what's the best way to make sure the crank aligns with the cam shafts so I can get the timing belt together and try starting it without bending valves and causing any damage?

And I was getting close to seeing if I could get it running again.

Back To Top PM Quote Reply  

 Posted: 03-10-2014 11:54 am
  PM Quote Reply
2nd Post
roland11a
Member
 

Joined: 12-11-2012
Location: Stone. Staffordshire, United Kingdom
Posts: 80
Status: 
Offline
If the crank has turned, and I guess by not much its not caught the valves. Just carefully  turn it back untill the markings on the timing belt sprockets line up again. If you take the plugs out so the engine turns easily you will feel if the piston contacts the valves if you turn iy carfully. Also you will see when No 1 is approching TDC

Back To Top PM Quote Reply

Current time is 04:18 am  
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Realign crank with camshafts Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems