| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Windshield Installation Sealant | Rating: 
|
| Author | Post |
|---|
| Posted: 11-06-2013 10:31 pm |
|
1st Post |
|
Bogie07 Member
|
In other posts, some say to use butyl tape, others say urethane sealant. There's also this 3M product http://www.amazon.com/3M-08609-Window-Weld-Urethane-Cartridge/dp/B000FW61EW/ref=sr_1_1?ie=UTF8&qid=1383780490&sr=8-1&keywords=windo-weld as well as the tape version, http://www.amazon.com/3M-08612-Window-Weld-Ribbon-Sealer/dp/B000CQ4AOO/ref=sr_1_6?ie=UTF8&qid=1383780602&sr=8-6&keywords=windo-weld which comes in different widths. My question is what is the best route to go? If it is the tape, what width would work best and is 15 ft enough for both sides of the windshield seal. Thanks.
|
||||||||||||||
| |||||||||||||||
| Posted: 11-09-2013 08:10 pm |
|
2nd Post |
|
Gary Martin JH 15371 Member
|
I think you could go either way, but the butyl tape on a roll must be heated up to make it pliable during install. For that reason I think the urethate in a tube applied with a calk gun would be better, its softer and less stress will be placed in the glass during install. Either way, I would have a professional install it. If it is cracked during install, it is difficult and expensive to get new glass. Gary Last edited on 11-09-2013 08:11 pm by Gary Martin JH 15371 |
|||||||||||||
| ||||||||||||||
| Current time is 06:49 am | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Windshield Installation Sealant | Top |
