Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Engine & Transmission > 4 speed transmission rear gasket replace

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
4 speed transmission rear gasket replace  Rate Topic 
AuthorPost
 Posted: 01-13-2013 08:40 pm
  PM Quote Reply
1st Post
Bob 13902
Member
 

Joined: 04-05-2006
Location:  
Posts: 32
Status: 
Offline
Looking for a clarification since manual a bit unclear - want to remove the rear casing (4 speed) to replace the gasket. Does something have to be done to the speedo first to ensure no damage to gear?

Back To Top PM Quote Reply  

 Posted: 07-16-2013 04:43 am
  PM Quote Reply
2nd Post
atgparker
Member


Joined: 06-23-2013
Location: Mission Viejo, California USA
Posts: 85
Status: 
Offline
No, the tail shaft housing will slip right off the out put shaft were there is a nice large plastic gear which drives the speedo cable housings gear and shaft which is screwed to the housing. 

As long as that small housing which the cable attaches to is not frozen up it will spin and allow the plastic gear to move the shaft as the tail shaft housing is pulled away from the center cast iron section of the transmission.

Back To Top PM Quote Reply

Current time is 01:26 pm  
> Jensen Healey & Jensen GT Tech > Engine & Transmission > 4 speed transmission rear gasket replace Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems