| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Cowl Shake | Rate Topic |
| Author | Post |
|---|
| Posted: 09-06-2011 06:11 pm |
|
1st Post |
|
Dakota123 Member
|
I imagine someone out there has installed strategic stiffening to reduce cowl shake and improve handling -- any photos or descriptions to share (other than the obvious full roll cage)? Thanks! Mike
|
||||||||||||||
| |||||||||||||||
| Posted: 12-07-2012 06:22 pm |
|
2nd Post |
|
roverman Member
|
If you feel scientific, you might do a torsional deflection test, as a baseline , before mod's begin. PITA bars,(diagonals) from front suspension/rail area, to load spreader plates, on the firewall, should help. These plates "might" be joined on the inside of firewall, with smaller diameter tubing, formed and welded to top or bottom corners, of the tunnel, to the rear kick-up area. Good Luck, roverman.
|
|||||||||||||
| ||||||||||||||
| Current time is 03:54 pm | |
| > Jensen Healey & Jensen GT Tech > Suspension > Cowl Shake | Top |
