Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Projects > Crankshaft pulley

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Crankshaft pulley  Rate Topic 
AuthorPost
 Posted: 07-10-2011 10:39 pm
  PM Quote Reply
1st Post
Cac41155
Member
 

Joined: 09-13-2010
Location:  
Posts: 9
Status: 
Offline
I noticed that the bearing plate (washer) which secures the crankshaft pully to the crankshaft is bent in. When I checked whether the shaft was flush with the outter edge of the pully I noticed that the shaft was recessed about 1/8". So when the nut is tighten it only presses up on the outter edge of the hole rather than the bearing surface (see photos attached). Photo1 - the bearing plate (washer).  Is this the way it is suppose to be; It doesn't seem right. Should there be a shim between the cranckshaft and the outter edge of the pully so the bearing plate doesn't bend inward or is it a matter of someone just overtightening?

Any help would be appriciated,

Angelo

Attachment: pullley1.jpg (Downloaded 139 times)

Back To Top PM Quote Reply  

 Posted: 07-11-2011 03:44 pm
  PM Quote Reply
2nd Post
Jensen Healey
Super Moderator


Joined: 03-11-2005
Location: San Anselmo, California USA
Posts: 983
Status: 
Offline
Just turn it over.

Back To Top PM Quote Reply

 Posted: 07-11-2011 07:25 pm
  PM Quote Reply
3rd Post
Cac41155
Member
 

Joined: 09-13-2010
Location:  
Posts: 9
Status: 
Offline
Ya, the more I thought about it, I can see that it is not that critical since there is a keyway so it really won't slip.

Back To Top PM Quote Reply  

Current time is 08:43 am  
> Jensen Healey & Jensen GT Tech > Projects > Crankshaft pulley Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems