| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Attachement points for clutch cable | Rate Topic |
| Author | Post |
|---|
| Posted: 06-02-2005 03:57 pm |
|
1st Post |
|
andrewo Member
|
Can anyone describe where the two tabs on the clutch cable are supposed to bolt to on the body? Thanks - Andrew
|
||||||||||||||
| |||||||||||||||
| Posted: 06-02-2005 06:32 pm |
|
2nd Post |
|
Mark Rosenbaum Member 
|
For LHD cars, the cable attaches to the PDWA using the same bolt that holds the PDWA to the left inner fender, and to the leftmost of the two most forward bolts securing the sump to the engine. The rubber anti-abrasion tube goes directly behind the latter point to protect the cable as it passes between the crossmember and the sump. Haven't a clue as to how it's done for RHD cars, but the cable is much shorter, so perhaps there's only a single mount point on the rightside frame rail.
|
|||||||||||||
| ||||||||||||||
| Posted: 06-02-2005 07:07 pm |
|
3rd Post |
|
Jim Ketcham Member
|
Hello Andrew, On my car the top tab connects to a small L bracket that attaches to the PDWA and the bottom tab connects to the bottom driver's side stud that holds the belt guard (shroud). I can email you a picture if you need it. Regards, Jim
|
||||||||||||||
| |||||||||||||||
| Current time is 10:44 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Attachement points for clutch cable | Top |
