Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Attachement points for clutch cable

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Attachement points for clutch cable  Rate Topic 
AuthorPost
 Posted: 06-02-2005 04:57 pm
  PM Quote Reply
1st Post
andrewo
Member
 

Joined: 06-01-2005
Location: San Diego, California USA
Posts: 51
Status: 
Offline
Can anyone describe where the two tabs on the clutch cable are supposed to bolt to on the body?

Thanks - Andrew

Back To Top PM Quote Reply  

 Posted: 06-02-2005 07:32 pm
  PM Quote Reply
2nd Post
Mark Rosenbaum
Member


Joined: 03-12-2005
Location: Kingman, Arizona USA
Posts: 532
Status: 
Offline
For LHD cars, the cable attaches to the PDWA using the same bolt that holds the PDWA to the left inner fender, and to the leftmost of the two most forward bolts securing the sump to the engine.  The rubber anti-abrasion tube goes directly behind the latter point to protect the cable as it passes between the crossmember and the sump.

Haven't a clue as to how it's done for RHD cars, but the cable is much shorter, so perhaps there's only a single mount point on the rightside frame rail.

Back To Top PM Quote Reply

 Posted: 06-02-2005 08:07 pm
  PM Quote Reply
3rd Post
Jim Ketcham
Member
 

Joined: 03-13-2005
Location: Salt Point, New York USA
Posts: 192
Status: 
Offline
Hello Andrew,

On my car the top tab connects to a small L bracket that attaches to the PDWA and the bottom tab connects to the bottom driver's side stud that holds the belt guard (shroud).  I can email you a picture if you need it.

Regards,

Jim

Back To Top PM Quote Reply  

Current time is 06:35 am  
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Attachement points for clutch cable Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems