Home 
Home Search search Menu menu Not logged in - Login | Register

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Oil Vapour cannister  Rate Topic 
AuthorPost
 Posted: 07-27-2010 07:19 am
  PM Quote Reply
1st Post
terryhowarth
Member
 

Joined: 03-02-2010
Location: Canberra, Australia
Posts: 19
Status: 
Offline
On 13599 I have the oil vapour cannister mounted on the drivers side firewall (RHD car ) it is a sealed unit and no obvious filter can be seen. It has 3 pipes connected to it, 1 to the air cleaners, 1 to the  block and the 3rd goes down to the sump plug. At the sump it has for want of a better phrase a "3 way splitter or T" it screws into the sump, then has the rubber hose into the side of it and on the end is the sump plug. Is this correct or has it been tampered with over the years? seems to me one piece of debri on the road and off comes the pipe and out comes the oil and goodbye engine.

has anyone seen this before or am I just astounded by 70s British engineering

Back To Top PM Quote Reply  

 Posted: 07-29-2010 10:19 pm
  PM Quote Reply
2nd Post
Greg Fletcher
Administrator


Joined: 03-11-2005
Location: Lake Nacimiento, California USA
Posts: 421
Status: 
Offline
1970's British engineering is astonishing. I once had an old Rover that had inboard rear disc brakes (above and in front of a DeDion rear axle)- after five hours of wrestling with it, I put it all back together exactly as I had found it with the original parts. Sounds completely correct for an early Jensen Healey. Not completely sure why they made that oil canister so complex, it is a bit funny to look at isn't it? I totally agree with you, they look fragile at best. I have never heard of one coming apart, however. I would certainly let sleeping dogs lie, as it were, and it makes for great conversation at car shows.

Back To Top PM Quote Reply

 Posted: 10-31-2010 12:36 am
  PM Quote Reply
3rd Post
whitedog1
Member
 

Joined: 11-07-2009
Location: State College, Pennsylvania USA
Posts: 6
Status: 
Offline
Anyone with a 'canister' Jensen care to share experiences/wisdom/upgrade stories??

Greg - thanks for reviving a forgotten memory - we must be close in age...I too wrestled a Rover rear end brake job (1972 Rover 2000tc) for several hours - couldnt get the caliper piston to retract to fit new pads. Seems that to retract, the piston has to be rotated within the caliper hole (if you made this stuff up, no one would believe ya). Ah...the pre-Internet era...I had to track down a hard to come by manual.

Back To Top PM Quote Reply  

Current time is 07:17 pm  
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Oil Vapour cannister Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems