| Moderated by: Greg Fletcher | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
Triplesn8s Member
|
Is there anyone on the forum to whom I can email some photos of a swaybar set for identification? I don't know if they are stock or aftermarket. Both front and rear are .875" diameter and zinc plated. The front has poly bushings, the rear mounts into what looks like factory punched holes in the rear lower control arm. I never heard of an OEM plating their bars. Alternatively if someone has a set of bars that are of known manufacture I would appreciate an emailed picture. I probably won't scrap them as I may be able to use them on something else (yeah, right) but I am not sure I want to spend a dollar to ebay them. TIA, Bill |
|||||||||
|
Greg Fletcher Administrator 
|
All the JH sway bars are aftermarket, that wasn't OEM. |
|||||||||
|
Jensen Healey Super Moderator 
|
The sway bars I got from Delta a few years back are plated. They require drilling holes in the rear spring seat area and in the front rails. The poly bushing stack in the front wears very quickly. I have some Delrin and will attempt to fabricate some replacements. Kurt |
|||||||||
|
atgparker Member 
|
Addco sway bar Kit Front Attachment: WP_000510.jpg (Downloaded 89 times) Last edited on 10-23-2013 04:35 am by atgparker |
|||||||||
|
atgparker Member
|
Addco Sway bar Kit Rear Attachment: WP_000512 (2).jpg (Downloaded 88 times) Last edited on 10-23-2013 04:35 am by atgparker |
|||||||||