Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Body & interior stuff > Trunk overhang measurement check needed

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Trunk overhang measurement check needed  Rate Topic 
AuthorPost
 Posted: 12-14-2008 11:55 pm
  PM Quote Reply
1st Post
Art DeKneef
Member
 

Joined: 03-12-2005
Location: Mesa, Arizona USA
Posts: 338
Status: 
Offline
Will some of you check and see if the rear edge of the trunk lid aligns across the back with the sheet metal or if there is an overhang near the middle? Near the edges of the depressed area where the license goes mine overhangs about 9/16 of an inch. On the ends it is flush with the metal. I'm not including the chrome trim piece in these measurements.

I checked a couple of pictures I have but can not tell from the pictures.

While test fitting the rear fenders and trunk lid on the 74 JH I'm rebuilding I noticed the edge of the trunk not lining up with the sheetmetal that has the tail lights. Didn't notice this before and thought it was unusual. So I checked the 73 I have and the two pieces pretty much align all the way across the back of the trunk lid.

The gap around the other three sides is pretty good so I'm curious if this was an unintentional result during the car's original build or from something else.

Thanks

Art

Back To Top PM Quote Reply  

 Posted: 12-15-2008 02:57 am
  PM Quote Reply
2nd Post
Jensen Healey
Super Moderator


Joined: 03-11-2005
Location: San Anselmo, California USA
Posts: 983
Status: 
Offline
Hi Art,

My '73 has an overhang in the center and is flush at the corners. I think you should check the fit of the trunk latch.

Good Luck,

Kurt

Back To Top PM Quote Reply

 Posted: 12-15-2008 01:49 pm
  PM Quote Reply
3rd Post
Art DeKneef
Member
 

Joined: 03-12-2005
Location: Mesa, Arizona USA
Posts: 338
Status: 
Offline
Thanks for checking Kurt. The lock mechanism and latch on the 73 work fine. On the 74 the latch was good. It just was stiff turning the key until I cleaned and lubed the pieces.

I'll wait and see if any others report their findings.

Art

Back To Top PM Quote Reply  

Current time is 05:51 pm  
> Jensen Healey & Jensen GT Tech > Body & interior stuff > Trunk overhang measurement check needed Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems