Home 
Home Search search Menu menu Not logged in - Login | Register

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Steering shaft  Rating:  Rating
AuthorPost
 Posted: 05-26-2008 01:56 am
  PM Quote Reply
1st Post
Ron Mau
Member
 

Joined: 03-14-2005
Location: Davenport, Iowa USA
Posts: 61
Status: 
Offline
Frustration prevails, It came off why won't it go back on.
 The steering shaft seems to not compact enough to fit. Is there a sequence that works?  I have been putting the upper knuckle on and then the lower knuckle, but it just doesn't want to cooperate. Any and all ideas will be appreciated.
 
Ron Mau
Davenport, IA

Back To Top PM Quote Reply  

 Posted: 05-26-2008 02:32 am
  PM Quote Reply
2nd Post
Jim Ketcham
Member
 

Joined: 03-13-2005
Location: Salt Point, New York USA
Posts: 208
Status: 
Offline
I've found it easier to loosen the 2 bolts on the steering rack which then gives you enough free play to line up the shaft and slip it on.

 

Back To Top PM Quote Reply

 Posted: 05-27-2008 12:22 am
  PM Quote Reply
3rd Post
Ron Mau
Member
 

Joined: 03-14-2005
Location: Davenport, Iowa USA
Posts: 61
Status: 
Offline
Thanks Jim,

Worked like a charm.  Only took a little while to get it done that way. Fiddled around alot longer to begin with.

Thanks again

Ron Mau

Back To Top PM Quote Reply  

 Posted: 03-10-2015 02:56 pm
  PM Quote Reply
4th Post
CoryB
Member
 

Joined: 01-25-2013
Location: Stanwood, Washington USA
Posts: 10
Status: 
Offline
Does anyone have tips on how to access the bolts on the steering rack?  I'm not convinced that mine are OEM, but getting to the nuts should be the same.  Thanks.

Back To Top PM Quote Reply

 Posted: 03-13-2015 04:24 pm
  PM Quote Reply
5th Post
answerman
Member
 

Joined: 09-10-2012
Location: Little Chute, Wisconsin USA
Posts: 435
Status: 
Offline
Waiting for the same answer... getting ready to order my new 4 into 1 exhaust header and I know removing the steering shaft is going to be part of the equation.

Back To Top PM Quote Reply  

 Posted: 03-13-2015 06:51 pm
  PM Quote Reply
6th Post
Jim Ketcham
Member
 

Joined: 03-13-2005
Location: Salt Point, New York USA
Posts: 208
Status: 
Offline
The two bolts that hold the steering rack pass thru the front cross member from front to back. The nuts (9/16" IIR) can be accessed from under the car (easiest with car on a lift) on the rear side of the front cross member. I use a socket with a long extension. The bolt heads are circular with a flat side that is supposed to keep the bolt from spinning.
When changing the steering shaft I just loosen the nuts to give enough freeplay of the rack to slip the shaft over the spline.

Good luck,
Jim

Back To Top PM Quote Reply

Current time is 01:31 am  
> Jensen Healey & Jensen GT Tech > Miscellaneous > Steering shaft Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems