Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Electrical & Instruments > Change bulb in side marker?

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Change bulb in side marker?  Rate Topic 
AuthorPost
 Posted: 05-12-2008 06:26 pm
  PM Quote Reply
1st Post
subwoofer
Member
 

Joined: 04-01-2008
Location: Sandefjord, Norway
Posts: 617
Status: 
Offline
The right rear side marker has burned out, and I have removed the marker from the car. Is there any way of opening it, so that the bulb can be replaced? I tried a bit of twisting and turning, but nothing came apart...

Any tips?

--
Joachim

Back To Top PM Quote Reply  

 Posted: 05-13-2008 01:24 pm
  PM Quote Reply
2nd Post
Brett Gibson JH5 20497
Member
 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
Pull the chrome cover out of the rubber, then you can just remove the lens, bulb is underneath, if it's corroded in try using a bit of acid to eat up the rust, but make sure you rinse it with water well, new bulb should have a bit of Dialectic grease on it for future removals. 

Back To Top PM Quote Reply

 Posted: 05-13-2008 06:22 pm
  PM Quote Reply
3rd Post
subwoofer
Member
 

Joined: 04-01-2008
Location: Sandefjord, Norway
Posts: 617
Status: 
Offline
Thanks, that worked. Was a bit too careful, the rubber is brittle after a long life in the sun.

--

Joachim

Back To Top PM Quote Reply  

 Posted: 05-13-2008 08:15 pm
  PM Quote Reply
4th Post
JodyFKerr
Member


Joined: 02-21-2008
Location: Tempe, Arizona USA
Posts: 48
Status: 
Offline
If the rubber is worn out you can get replacements from Delta.

Back To Top PM Quote Reply

 Posted: 05-14-2008 08:59 pm
  PM Quote Reply
5th Post
edward_davis
Member


Joined: 07-06-2005
Location: Eugene, Oregon USA
Posts: 162
Status: 
Offline
The replacements aren't exactly the same, from what I can tell.  The part is almost the same as the one on an MGB, which seems to be what Delta has.  The difference is the angle of the sheet metal under the light, so the new ones don't sit as nicely as the originals.  But if the originals are shot, what can you do?

I'm making this remark based on some cars I've seen at shows (managed to save my original rubber bits so far).  I may be incorrect: the folks with those cars may have just gotten MGB bits from Moss or some other MG specialist and Delta might have the correct ones.  So I shouldn't come down so strong.  Let me leave it like this: the replacement rubber bits may or may not have the same angle as the original ones, but they will keep water out of the light....

Edward

Back To Top PM Quote Reply  

Current time is 06:12 pm  
> Jensen Healey & Jensen GT Tech > Electrical & Instruments > Change bulb in side marker? Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems