Home 

 Moderated by: Greg Fletcher  
AuthorPost
12371
Member
 

Joined: 09-22-2006
Location:  
Posts: 17
Status: 
Offline

I was doing some work on the center console, (new radio, wood trim ect.) and in my zeal I pulled the choke cable out of the engine compartment to clean and lube it.  Now I can't figure out where it penetrates the firewall back to the engine compartment.  It's pretty tight under there, heater core and all, I'm either looking too hard in the wrong place or I've got more work than I planned to do to run this thing back where it belongs.

Anyone know off the top of their heads how the cable is routed?

Lash Russell
Member


Joined: 07-23-2005
Location: Franktown, Colorado USA
Posts: 69
Status: 
Offline
     On my car it runs through the firewall directly beside the foot pedal box.  If you look at the firewall (engine side) directly to the left of the aluminum foot pdal box protruding the firewall you will see a set of four smaller holes in a diamond spaced pattern.  These holes are also located below the speedometer cable hole.  The right hole of the of the four diamond shaped spaced holes is for the choke cable.  Hope this helps.

Lash

12371
Member
 

Joined: 09-22-2006
Location:  
Posts: 17
Status: 
Offline

Thanks for checking.  I assumed it was easier to get to than I thought, it just seemed a long routing to get to the carbs.

Thanks again,

George



UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems