Home 
Home Search search Menu menu Not logged in - Login | Register

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Choke Cable  Rate Topic 
AuthorPost
 Posted: 05-01-2008 05:45 pm
  PM Quote Reply
1st Post
12371
Member
 

Joined: 09-22-2006
Location:  
Posts: 17
Status: 
Offline

I was doing some work on the center console, (new radio, wood trim ect.) and in my zeal I pulled the choke cable out of the engine compartment to clean and lube it.  Now I can't figure out where it penetrates the firewall back to the engine compartment.  It's pretty tight under there, heater core and all, I'm either looking too hard in the wrong place or I've got more work than I planned to do to run this thing back where it belongs.

Anyone know off the top of their heads how the cable is routed?

Back To Top PM Quote Reply  

 Posted: 05-01-2008 07:31 pm
  PM Quote Reply
2nd Post
Lash Russell
Member


Joined: 07-23-2005
Location: Franktown, Colorado USA
Posts: 69
Status: 
Offline
     On my car it runs through the firewall directly beside the foot pedal box.  If you look at the firewall (engine side) directly to the left of the aluminum foot pdal box protruding the firewall you will see a set of four smaller holes in a diamond spaced pattern.  These holes are also located below the speedometer cable hole.  The right hole of the of the four diamond shaped spaced holes is for the choke cable.  Hope this helps.

Lash

Back To Top PM Quote Reply

 Posted: 05-02-2008 03:30 pm
  PM Quote Reply
3rd Post
12371
Member
 

Joined: 09-22-2006
Location:  
Posts: 17
Status: 
Offline

Thanks for checking.  I assumed it was easier to get to than I thought, it just seemed a long routing to get to the carbs.

Thanks again,

George

Back To Top PM Quote Reply  

Current time is 10:42 am  
> Jensen Healey & Jensen GT Tech > Body & interior stuff > Choke Cable Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems