View single post by Jensen Healey
 Posted: 04-04-2010 04:15 pm
PM Quote Reply Full Topic
Jensen Healey



Joined: 03-11-2005
Location: San Anselmo, California USA
Posts: 977
Status: 
Offline
Hi Garry,

Welcome! I remember at least one at least one article by you in the club magazine some years back. It's great to see you on the forum.

I have completed the work with pulleys from Mike Taylor.

All that's left to do is take it to a local shop for a co reading. I drilled the idle jets to .56mm and installed .7 Idle jet holders from Eurocarb. The engine runs up (under the load of a 2nd gear start) through the rpm range with no flat spots but there's no urgency. I think it's still a tad lean.

Thanks for the offer,

Kurt Housh

JH 13148