View single post by Greg_M
 Posted: 02-19-2010 07:26 am
PM Quote Reply Full Topic
Greg_M

 

Joined: 09-26-2009
Location: Lakewood, Washington USA
Posts: 38
Status: 
Offline
 I don't think that would be possible on my engine.  The alloy pulley is just too thin walled to do this to it.  I can see that on a steel version of this pulley I have that it would be possible, but I don't want to change it.  The web site you referenced makes a 2" wheel that I think I can fit inside a Lucas distrubitor housing.  I would remove the cam and counter weights, mount the wheel to the shaft and mount the sensor to the plate the points mount on.  I would just need a cover to enclose  the whole setup. A used distrubitor cap would work until I could find something better.  This would give me a little project to do until the weather improves.

 

Cheers