 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 12-17-2009 |
| Location: | Hailey, Idaho USA |
| Posts: | 83 |
| Status: |
Offline
|
3.1 pints for the 4 speed, 4.2 pints for the 5 speed.
Ok, now I'm really confused on how much fluid to put into my Mk1 4 speed!
The workshop manual says (page B12.25): "...then fill the gearbox with 3.5 Imp. pints (4.2 U.S. pts., 1.99 litres) of an approved lubricant..."
If I just pump fluid in until it reaches the bottom of the fill plug the transmission will take about 5 U.S. pints. Since I had 3 quarts of Royal Purple MTL I used this approach. WRONG - now my clutch releases very slooowwwllllyyy.
So the question is: how much should I now drain from the transmission?
Thanks in advance for any insight.