 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-05-2005 |
| Location: | Boyds, Maryland USA |
| Posts: | 88 |
| Status: |
Offline
|
| View single post by George | |||||||||||||
| Posted: 06-16-2005 02:49 am |
|
||||||||||||
George
|
Had this same problem recently. You have to unbolt the cable from up front at the carbs and pull it thru. I guess some people replace the mounting so it is off to the side of the panel, but I reallyy didn't have any trouble pulling mine and then rethreading it. Ended up doing it a few times. Mine is a solid wire rather than braided (not sure if it is stock), which would,I am sure, make the rethreading much more difficult.
|
||||||||||||
|
| |||||||||||||