View single post by Brett Gibson JH5 20497
 Posted: 03-02-2009 01:42 pm
PM Quote Reply Full Topic
Brett Gibson JH5 20497

 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
Dan, its been awhile since  I redid mine, but if memory serve correct there should have been a small plastic pin that keeps the inner shaft connected to the outer, and I do mean small, I broke mine while messing with it but it turned out not to be an issue, I just reinstalled without and it has been good to go since, 3 plus years.

If you install something a bit more rigid, cotter pin, you might end up not allowing the column to colapse should there ever become a time when you need it to.

As for installing it, I had my column in place, and the lower universal lossened up to allow room to slip the upper over the column.

Brett