View single post by Lash Russell
 Posted: 12-01-2008 11:04 pm
PM Quote Reply Full Topic
Lash Russell



Joined: 07-23-2005
Location: Franktown, Colorado USA
Posts: 69
Status: 
Offline
Hi Ross,

    I've had this problem a couple of times.  The brass plug will only get worse as time goes by.  It was a while ago but the last time I battled with the oil drain plug I ended up drilling a hole through the side of the plug and tapping a puch into the hole then using this like a wrench to turn the plug out.  Not an elegant solution but effective.

    After that, install a new steel plug (Delta has them, probably others as well).  When I ordered from Jim at Delta I also got the seals. 

Hope this helps a bit,

Lash