View single post by kneff
 Posted: 06-02-2005 05:16 pm
PM Quote Reply Full Topic
kneff

 

Joined: 04-06-2005
Location: San Jose, California USA
Posts: 21
Status: 
Offline
 See- I knew someone would have a clever answer! Putting a wrench on the top nut and then rotating the mount hadn't occurred to me. Of course, tightening up the new top nut won't be as simple. I think I'll go buy the stubbiest wrench I can find.

Where do you place jack stands in the front? I assume I will jack from the center of the front subframe (directly under the engine) but are there reinforced points for jack stands?

Thanks,
Ken