View single post by Mark Rosenbaum | |||||||||||||
Posted: 06-02-2005 01:54 am |
|
||||||||||||
Mark Rosenbaum
|
Yep, that's all. Pull the round plug, then jumper pins 11 and 12. This connects the START wire from the ignition switch to the hot side of the coil on the relay used to activate the starter solenoid. Alternately, pull the round plug, then connect pin 12 to an 'Engine Start' pushbutton such as that used in the Honda S2000. The second side of the button would be wired to a source of switched or direct battery voltage, perhaps with an added inline fuse. Attachment: red button.jpg (Downloaded 154 times)
|
||||||||||||
|