View single post by Jensenman
 Posted: 09-23-2008 12:03 pm
PM Quote Reply Full Topic
Jensenman

 

Joined: 04-14-2005
Location: Columbia, South Carolina USA
Posts: 156
Status: 
Offline
 I used a 86 RX7 speedo cable for my setup, I had to swap the speedo end sleeve from the original cable to the RX7 piece. I also had to make an eccentric sleeve for my speedo drive on the trans to allow the use of a 30 tooth speedo gear.

A buddy of mine just finished an LS1 swap into a 1990 RX7. The GM tranny has an electronic speedo sender and the RX7 has a cable driven unit. He sourced an adapter which uses the electronic signal to drive a small electric motor which then spins the speedometer through a cable.


http://www.hawksthirdgenparts.com/electronictomechanicalspeedometerbox.aspx

Last edited on 09-23-2008 12:07 pm by Jensenman