 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 02-14-2006 |
| Location: | Bloomfield/Hebron, Connecticut USA |
| Posts: | 147 |
| Status: |
Offline
|
I've had two of these units fail on 15851. The last time I ran a small jump wire from pins 11 to 12 as you say, it solved the problem. Do not remove the OEM wires to these pins, just use a short length or wire, about 3/8" long, bent into a U shape to go from pin to pin on the female side of the connection. The ISBWM is a rectangular metalic box about 2" x 4", with a circular section (buzzer) on the top. It's located on the left side of the drivers footwell, about 18" 24" up from the floor near the bulkhead. It's retained by two philips head screws, and it's easier to run the jump wire if you remove it. I bought a working used unit as a spare, you may want to do the same. Good luck, Colin
http://jhppg.com/gallery/74-Jensen-Healey-15851