View single post by Jim Ketcham
 Posted: 05-26-2008 02:29 pm
PM Quote Reply Full Topic
Jim Ketcham

 

Joined: 03-13-2005
Location: Salt Point, New York USA
Posts: 208
Status: 
Offline
Actually, the bolt that holds the pulley should have no pressure on it.  There should be an allen screw plug that screws and seats into the cam thus sealing the oil passage before it gets to the pulley bolt.  The allen screw plug should be sealed.  For Frank's application, it is not necessary to remove so he should have no problem.

Second thought, should check that the plug is in place by sticking a wire into the bolt hole.  It seats approximately 2 inches in (just shy of the oil feed hole).