 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-13-2005 |
| Location: | Salt Point, New York USA |
| Posts: | 208 |
| Status: |
Offline
|
I have had problems with the new aux. housing seal and front cover seals that come in the gasket kits from Delta and found that they were not optimally sized. If your leak is indeed the cam tower seal you should be able to finess a new one in without pulling the tower. You should be able to get the old one out with a seal puller. Install new one with lip well lubed and, if I recall correctly, a 2'' pipe coupling fit over the cam and allowed pressing in the new seal FLUSH. DO NOT press in beyond the face being flush as you will block the oil feed hole. Good luck.