View single post by dwalls1
 Posted: 04-21-2008 01:58 am
PM Quote Reply Full Topic
dwalls1

 

Joined: 04-11-2008
Location: Bloomfield, New Mexico USA
Posts: 207
Status: 
Offline
Just checked out your beautiful yellow one.  Am interested in the work on the floor panels. Only the drivers side is bad on mine and then only under the seat. Which explains why the headrest on that side appeared to be lower than the other. It was. Was going to replace seat foam on drivers side when I found it rusted through under the rear of the seat. So much for my "rust free California car". But it could certainly be much worse and was encouraged to find none under the pass. side. Any advice or encouragement appreciated. Dale