View single post by demonicus
 Posted: 01-06-2008 04:35 am
PM Quote Reply Full Topic
demonicus

 

Joined: 12-30-2007
Location:  
Posts: 12
Status: 
Offline
The only engine flush additive that any mechanical device needs is

SEAFOAM... http://www.seafoamsales.com

I swear by this stuff... anything else is simply an additive with harsh chemicals designed to eat your money and your motors. Here in vancouver the only generic parts store that carries it is NAPA.

The directions with one bottle is to put half in your crankcase, 25% in the pvc valve hole or intake(s) with the motor running and then shut off the motor. let it sit for 5 - 10mins and then fire it up again. The last 25% goes into your gas tank at a 1/4 full.

Run the vehicle for 100kms -250kms and then give it an oil change. Decide how long it has been since the last change to figure out if you should drive the 100 or 250kms.

example is if I haven't done an oil change in along time I would only drive 100kms and then change the oil. If your religious like me about every 3 - 5000kms then you can let the seafoam sit in the crankcase for 250kms. No more tho.

you can see videos of seafoam users on youtube and streetfire.net