Dan Eiland
|
The JH uses a different A/C setup than the GT. I have tried to locate a GT A/C system but no one will sell me the parts. The parts that are on my car are correct for the JH. I suspect I just need to move the engine back a little. The JH requires the longer crank pulley to align the belt correctly with the compressor. I have three different pullies and the one on there is the only one that aligns the belt. I can always cut the lip off the shroud but I don't know if that would weaken the shroud and cause vibration. I'll look at this over the weekend and decide what route to take to correct this issue.
|
