View single post by pbahr
 Posted: 11-06-2007 05:08 pm
Full Topic
pbahr



Joined: 04-15-2005
Location: Moorestown, New Jersey USA
Posts: 198
Status: 
Offline
Hi Erik,

Well, I am making the Clutch Lever Boot available to the JH community.  The Boot mounting slot is 3  1/4 X 1  7/8  inches, so it will fit a Bellhousing hole a bit larger than that,  and a thickness of less than 5/16.  Attached pix shows how the Lever/Boot/Bellhousing fit together.

Sorry, but I need both the Firewall and Bellhousing Brackets as a core before I can ship the Damper Kit - it was a real pain to get a few Bracket cores when I started this Kit a couple of years ago.  I have to do a fair amount of cutting and welding on the Brackets, and it's not worth it to do one at a time, so I do about six at once.

Send me an email to: PETEB01@COMCAST.NET , and I'll email all the details to you.

This Forum is not intended to be used as a sales platform, so I would rather do this stuff off-line.  I'm sure you understand.

Thanks,

Pete Bahr (YELODOG)

Attachment: Boot in Bellhousing 003liteS.jpg (Downloaded 85 times)