View single post by edward_davis
 Posted: 09-09-2007 04:04 am
PM Quote Reply Full Topic
edward_davis



Joined: 07-06-2005
Location: Eugene, Oregon USA
Posts: 162
Status: 
Offline
 I did this last year, and all you need is a sllide hammer that you can attach to the lugnuts.  One or two gentle taps, and it'll come out.  THe old bearing has to be pressed off, and the new one on.  I had my local LBC mechanic do it.  You'll need heat to get the new bearing retainer on, but you shouldn't need any heat to get the half shaft out of the axlehousing.

Edward