 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-29-2006 |
| Location: | Los Angeles, California USA |
| Posts: | 1 |
| Status: |
Offline
|
Last edited on 03-30-2007 02:33 am by s16454
| View single post by s16454 | |||||||||||||
| Posted: 03-30-2007 02:32 am |
|
||||||||||||
s16454
|
Here's an idea I'm going to try. I just finished rebuilding the two carbs on my car and I have a good used throttle bypass diaphragm/gasket. I noticed it is very similar to the vacuum switch diaphragm in size and pattern. I'm simply going to drill a hole in the brass center for the rod and trim and/or modify the gasket portion to match the original. Has anyone tried this yet? Last edited on 03-30-2007 02:33 am by s16454 |
||||||||||||
|
| |||||||||||||