View single post by Dan Eiland
 Posted: 03-29-2007 05:37 am
PM Quote Reply Full Topic
Dan Eiland

 

Joined: 03-18-2005
Location: El Paso, Texas USA
Posts: 159
Status: 
Offline
 After writing my last reply it hit me that one of the shims probably slipped out of place causing the clearance on one of the valves to go to zero. I ran out to the garage and removed the cam carrier and I was right. I put it back in place and everything is either .006 or .007 with the exception of two valves. I'll order new shims for the two valves that are still out of spec and that should take care of setting the valve clearances.