 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 10-21-2005 |
| Location: | Eastanollee, Georgia USA |
| Posts: | 72 |
| Status: |
Offline
|
I removed my gaskets and had a machinist buddy surface grind 8 shims down to 0.060" (minimum recommended) that I used to figure out what I needed to order.
Note: DO NOT surface grind shims to run in the engine. I believe that they are case hardened and you will grind off the hardening (Someone correct me if I am wrong).
I still have them and if you e-mail me (limey01@aol.com) your mailing address would gladly send them to you (or anyone else that could use them).
Andy 15223