View single post by Jim Ketcham
 Posted: 01-21-2007 01:28 pm
PM Quote Reply Full Topic
Jim Ketcham

 

Joined: 03-13-2005
Location: Salt Point, New York USA
Posts: 208
Status: 
Offline
 Hello Frank,

I have done two now by combining parts from several.  The manual is actually quite good and the project is straight forward.  The PROBLEM IS PARTS.  In my experience I have found the "shift selector forks" almost always worn to the point of allowing popping out of gear.  UNFORTUNATELY, they are very hard to come by and rediculously expensive.  Bruce Madden was the last source that I know of.  You may be better off finding spare transmissions to cobble for parts.

Jim