View single post by Mark Kleimola
 Posted: 01-05-2007 10:07 pm
PM Quote Reply Full Topic
Mark Kleimola

 

Joined: 11-16-2006
Location:  
Posts: 7
Status: 
Offline
 I too am in the process of installing cams and shimming the valves. Since I have switched over from the old base cams to the 107 cams I had, I find I need mostly all new shims.

The new shims I need range from ~.100-.110 (exhaust) to about ~0.110-0.125 (inlet) based on my dry assembly without shims. Are these sizes readily available?  All the shims in my possession range from 0.070 to about 0.095.

Also if by chance someone has some thick ones they would swap for some thin ones 3 thin for 2 thick, or even want to sell, I'm open.

Let me know at mkleimol@comcast.net..
 


Thanks
Mark K