 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 11-30-2006 |
| Location: | |
| Posts: | 3 |
| Status: |
Offline
|
The block is currently undergoing a dye penetrant test, but I was curious if the 907 was normally repaired in this manner.
| View single post by Erzulis Boat | |||||||||||||
| Posted: 12-01-2006 02:20 pm |
|
||||||||||||
Erzulis Boat
|
The repair was already present. After stripping the block, the telltale weld penetration bead was present at the base of the water jacket near the cylinder bore. Externally,but very faint, were the die-grinder marks. The block is currently undergoing a dye penetrant test, but I was curious if the 907 was normally repaired in this manner.
|
||||||||||||
|
| |||||||||||||