View single post by Dan Eiland
 Posted: 11-08-2006 01:28 pm
PM Quote Reply Full Topic
Dan Eiland

 

Joined: 03-18-2005
Location: El Paso, Texas USA
Posts: 159
Status: 
Offline
Ron, any idea how many roll pins would be needed? With the high torque starters today and HC engines, you could be placing quite a bit of torque onto some very small roll pins causing some major shear forces to be present. I would think it would take several roll pins to overcome, or at least spread out, the shearing forces to more than one pin. I have heard of using roll pins before, just not how many or what size.