View single post by Tom Thomson
 Posted: 08-20-2006 12:08 am
PM Quote Reply Full Topic
Tom Thomson

 

Joined: 03-18-2005
Location:  
Posts: 33
Status: 
Offline
 Bob:

  I had trouble with the door fit and it turned out to be that the car was bending.  The jump seat/package shelf at the juncture with the drive shaft tunnel was cracked from each corner in on about a 45 deg angle.  This obviously weakened the car a lot and was allowing it to flex.  I get goose bumps thinking what was going to happen when those two cracks met.  16971 (my current project) has the same problem.

                                                      Tom 13753