 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-13-2006 |
| Location: | Lodi, California USA |
| Posts: | 25 |
| Status: |
Offline
|
Any suggestions would be helpful. Thanks
Jim
| View single post by 73healey | |||||||||||||
| Posted: 07-25-2006 02:55 pm |
|
||||||||||||
73healey
|
I have purchased and received the dash kit from Madera Concepts. Everything looks pretty straight forward except the installation of the piece to the left of the steering column. I have an early car but it has the stuck on veneer to a metal plate. Do I adhere the new wood to the metal plate? If I do this, how do I get the bottom molding to line up correctly as it has now been pushed out about 1/4 inch? Can I assume that the clock trim piece is glued also to the metal plate? If glue is used, what is the correct type? Any suggestions would be helpful. Thanks Jim
|
||||||||||||
|
| |||||||||||||