View single post by Jim Ketcham
 Posted: 05-29-2006 06:23 pm
PM Quote Reply Full Topic
Jim Ketcham

 

Joined: 03-13-2005
Location: Salt Point, New York USA
Posts: 208
Status: 
Offline
 Hello Ty,

Sounds like a PO did not press the bearing in all the way to spec.  during an overhaul.  You really should not try to press while it is installed.  Even with the pump out one has to be very careful pressing in the bearing and backing up the casting so as not to crack the casing. 

Jim