View single post by vnavaret
 Posted: 06-14-2025 06:08 pm
PM Quote Reply Full Topic
vnavaret



Joined: 04-07-2022
Location: Oregon USA
Posts: 104
Status: 
Offline
 Yes, you are shrinking them too much, but at least you got one to post =:-)

Hard to tell, but it looks to me like all you need to do is clean up the rust, and replace the cross members/seat mounts. Of course if there is some fiberglass in there, I can't see it when the picture is that small.

Your floors look very much like mine did, but I could poke a screw driver through in numerous spots. Needless to say I was having a very bad day at that point.

Cross members are cheap, and do not require much in the way of welding. I bought a cheapie $200 flux welder, which did the job.

Vance