 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 07-14-2022 |
| Location: | Penticton, British Columbia Canada |
| Posts: | 42 |
| Status: |
Offline
|
Your post jogged my memory of what may be causing the engine to bind.
When I replaced the rear seal I found the a PO had secured the seal housing with phillips head machine screws (see attached pic). I ordered some cap head screws to replace the fasteners, but found that when I torqued the flywheel some of them would bind. I ended up reusing the screws in a few spots and everything moved freely.
It could be that the clutch pressure is enough to cause binding in this area, although it certainly seemed that clearance was adequate.
I should know more after I do as you suggested.
Attachment: seal cover.jpg (Downloaded 52 times)