View single post by redracer
 Posted: 09-20-2021 01:10 am
PM Quote Reply Full Topic
redracer

 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 517
Status: 
Offline
Here's good advice for anyone redoing their front suspension. The lower arm has 2 pices of support for the bolt on the backside, but only one "meager" support for the front of the bolt(see pix). For all the one I redo, I cut a circular piece of 1/8" + metal(one inch diameter or a little more is fine) to add strenght to the tremenduous force put on this area(see pix).
Hope this helps, bruce[img][/img]

Attachment: J-H front subframe lower arm welded support.jpg (Downloaded 28 times)