 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-12-2005 |
| Location: | Washington USA |
| Posts: | 116 |
| Status: |
Offline
|
John.
| View single post by John Kimbrough | |||||||||||||
| Posted: 11-04-2005 10:55 pm |
|
||||||||||||
John Kimbrough
|
Thanks for the input, guys. 20 or so years ago I did drop the front end out of the body to remove/repair the exhaust header, so I must have somehow disconnected the crossmember outriggers, but damned if I can remember how difficult it was. To replace the bushings, I would probably have to disconnect enough to allow me to at least lift the body away from the crossmember outrigger. Probably more than I want to do now. Appreciate your thoughts, but will pass this time unless someone else can come up with some magic. John.
|
||||||||||||
|
| |||||||||||||