View single post by Harkes
 Posted: 11-09-2020 01:54 pm
PM Quote Reply Full Topic
Harkes



Joined: 03-17-2005
Location: Warmond, Netherlands
Posts: 216
Status: 
Offline
Hi Bruce,

thanks and well spotted. My drill is a cordless one which goes up to about 250 rpm and I didn't run it at full speed either as I was still using the allen bit and I didn't want to ruin the aux pulley allen bolt.

I think to be honest I did not spin the aux pulley long enough the first time around. I stopped when I saw lots of oil coming up at the cams and thought that was good enough.

Second time around I waited until oil came out the other end of the oil pressure line which took just a little longer... I don't think the oil pressure line was clogged or anything as almost nothing came out when I blew it out with pressed air.