View single post by cjwilson
 Posted: 03-25-2020 07:12 pm
PM Quote Reply Full Topic
cjwilson

 

Joined: 04-23-2006
Location: San Antonio, Texas USA
Posts: 50
Status: 
Offline
 Since my tach has never functioned since I bought the car, I decided it was probably stupid of me to trust resoldering replacement parts into the same holes they were desoldered from.

Now that I am looking at the tach with cynicism, I see that the red wire feeding into one of the coils is not connecting to anything via the board. It is soldered to the board, but nothing else is soldered to the same contact. And there is an empty hole at the other end of the solder point.

Does anyone have a few good pics of what is to get soldered where on their tach?