 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 01-25-2013 |
| Location: | Stanwood, Washington USA |
| Posts: | 10 |
| Status: |
Offline
|
| View single post by CoryB | |||||||||||||
| Posted: 05-23-2019 11:38 pm |
|
||||||||||||
CoryB
|
UPDATE: I found that on my "SnugTop", a 3/4 inch round foam seal works perfect. I simply glued the foam seal into the recess that goes around the bottom of the top. The top does not actually sit on the body it is supported by the front windshield and the attach bolts just behind the seats. The foam seal only "seals" the gap and takes very little weight. I have no idea if this would work on other brand tops, but it fits the SnugTop just fine. Thanks for all the suggestions
|
||||||||||||
|
| |||||||||||||