 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 07-10-2012 |
| Location: | Whitehills , United Kingdom |
| Posts: | 168 |
| Status: |
Offline
|
Gordon
| View single post by gmgiltd | |||||||||||||
| Posted: 03-15-2019 02:49 pm |
|
||||||||||||
gmgiltd
|
Hi Tim, you don't need to take off the head to shim the valves - just the cam housings and they no longer use gaskets. It a fiddly time consuming job though especially if you are trying to get the clearances exactly the same and not just within spec - you may have to take them off and on more than once. Gordon
|
||||||||||||
|
| |||||||||||||